Pi setup


  • I imaged my SD card with Raspbian for robots OS. I used the below tutorial to do it:


  • I then put the SD card in the Raspberry pi and installed VNC viewer on my laptop. The below links are where i downloaded the VNC viewer from.


  • I powered up my robot and connected my laptop to my robots network.

  • Then I used VNC viewer to connect with IP 10.10.10:1 and boot up my pi and log into it with 
    • username: pi
    • password: robots1234

  • This screen should come up after you login:
Image result for raspbian for robots bootup screen

  • I followed the tutorial from below pdf to configure my pi.


Comments

Post a Comment

Popular posts from this blog

My GoPiGo solving maze using remote control

Image
I have written a python script for my pi to take picture every sec for the number of seconds i give it using webcam to increase my database. I also wrote a python script for my GoPiGo to go forward, backward, left and right based on my commands and I also lowered the speed for my pi to get accurate pictures while moving. Here is a small video Demonstrating all the tasks i mentioned above: I installed Tensorflow on my pi and I am working on my python script to use the results from tensorfow to use as input for my gopigo remote control script.
Read more